Photoelectric Sensor | E3Z-R61 2M | Omron

Brand:       Omron

Model:       E3Z-R61 2M

Type:         Photoelectric Sensor

Introduction

Compact housing size and high power LED for excellent performance-size ratio

IP67 and IP69k for highest protection in wet environments.

Eliminates the influence of installation and on-site conditions, thus increasing the reliability of the line.

The system can detect tiny objects as little as 0.1 mm in diameter with its 2.5-mm dia. spot.

The thin beam enables detection through gaps or small holes.

The high-intensity spot of light enables visual alignment of sensing spot position.

Make sure that the power supply to the Sensor is within the rated voltage range. If a voltage exceeding the rated voltage range is supplied to the Sensor, it may explode or burn.

Be sure to connect or disconnect the metal connector after turning OFF the Sensor.

Hold the connector cover to connect or disconnect the metal connector.

Secure the connector cover by hand. Do not use any pliers, otherwise the connector may be damaged.

The proper tightening torque range is between 0.3 and 0.4 N·m. Make sure to tighten the connector securely, otherwise you may not maintain the specified degree of protection or vibrations may disconnect the connector.

Do not connect the power supply to the Sensor with no load connected, otherwise the internal elements may explode or burn.

If you turn on the sensor before powering the load, it will start working in 100 MS. Make sure to turn on the sensor before powering the load if the load and sensor are connected to separate power supplies.