Photoelectric Sensor | E3Z-LS63 | Omron
The Omron E3Z series photoelectric sensor having NPN type output. This sensor has a diffuse type sensing method. It has a sensing capacity up to 80 mm. Compact housing size and high power LED , IP67 degree of protection.
Brand: Omron
Model: E3Z-LS63
Type: Photoelectric Sensor
Introduction:
Omron E3Z-LS63 , Distance-setting, Sensing distance 2 to 80 mm, Light-ON/Dark-ON selectable, NPN, Pre-wired models (2 m), Red LED (650 nm) ; Sensing method, Distance-setting.
Make sure that the power supply to the Sensor is within the rated voltage range.
Short-circuiting the load may damage the sensor.
Do not connect the power supply to the Sensor with no load connected, otherwise the internal elements may explode or burn.
The Sensor is ready to operate 100 ms after turning ON the Sensor. If you connect the load and Sensor to independent power supplies respectively, make sure to turn ON the Sensor before supplying power to the load.
Always turn OFF the power supply to the Sensor before connecting or disconnecting the metal connector.
Hold the connector cover to connect or disconnect it. If the XS3F is used, always tighten the connector cover by hand. Do not use pliers, Vibration or the lack of proper protection of the Sensor may cause the connector to be disconnected if it is not securely connected. The appropriate tightening torque is 0.3 to 0.4 N·m. If you use other commercially available connectors, follow the recommended connector application conditions and recommended tightening torque specifications.
If Sensors are mounted face-to-face, make sure that the optical axes are not in opposition to each other. Otherwise, mutual interference may result.
Always install the Sensor carefully to avoid directly exposing it to intensive light, such as sunlight, fluorescent light, or incandescent light.
Do not strike the Photoelectric Sensor with a hammer or any other tool during the installation of the Sensor, or the Sensor will lose its water-resistive properties.
Use M3 screws to mount the Sensor.
When mounting the case, make sure that the tightening torque applied to each screw does not exceed 0.54 N·m.
Make sure that the sensing side of the Sensor is parallel with the surface of the sensing objects. Normally, do not incline the Sensor towards the sensing object. In case the sensing object has a glossy surface, however, incline the Sensor by 5° to 10° as shown in the illustration, provided that the Sensor is not influenced by background objects.
| Specification | Detail |
|---|---|
| Shape | Square Type |
| Sensing Method | Distance- setting |
| Sensing Distance | 2 to 80mm |
| Setting Range | White Paper 25 x 25 mm: 20 to 80 mm |
| Detection Range |
2 mm to Setting distance (80 mm max.) |
| Differential Distance |
2% max. of setting distance |
| Reflectivity Characteristic | 5% max. of setting distance |
| Light Source | Red LED (650 mm) |
| Power Supply Voltage | 12 to 24 VDC±10% ripple (p-p) 10% max. |
| Current Consumption | 30 mA max |
| Operation Mode | Light-ON/Dark-ON select-able |
| Response Time |
Operate or reset: 1 ms max. |
| Sensitivity Setting |
5-turn endless adjustment |
| Ambient Temperature Range (Operating) |
-25 to 55 ℃ (with no freezing or condensation) |
| Ambient Temperature Range (Storage) | -40 to 70 ℃ (with no freezing or condensation) |
|
Ambient Humidity Range (Operating) |
35 to 85% (with no condensation) |
| Ambient Humidity Range (Storage) | 35 to 95% (with no condensation) |
| Connection Method | Pre-wired models (Cable length 2 m) |
