Description

Omron E3Z-R86 Photoelectric Sensor

Brand:                                                            Omron

Model NO:                                                   E3Z-R86

Type:                                                 Photoelectric Sensor

Product Description:

Wiring

Make sure that the power supply to the Sensor is within the rated voltage range.

Load Short-circuiting

Do not short-circuit the load, otherwise the Sensor may be damaged.

Connection without Load

Do not connect the power supply to the Sensor with no load connected, otherwise the internal elements may explode or burn.

Power Reset Time

It’s important to remember that when the load and sensor are connected to separate power supplies, you should always turn on the sensor before supplying power to the load. This ensures that everything operates smoothly and in the correct order.

M8 Connector

• Always turn OFF the power supply to the Sensor before connecting or disconnecting the metal connector.
• Hold the connector cover to connect or disconnect it.
• Always tighten the connector cover by hand if using the XS3F. Do not use pliers.
• Vibration may disconnect the connector if it is not connected securely or may not maintain the proper degree of protection of the Sensor.
• When using other connectors, follow the recommended application conditions and tightening torque specs.

Mounting the Sensor

• Make sure that the optical axes are not in opposition to each other when mounting Sensors face-to-face. Otherwise, mutual interference may result.
• It’s important to install the sensor carefully to avoid direct exposure to intense light sources like sunlight, fluorescent light, or incandescent light. This will ensure optimal performance.
• Do not strike the Photoelectric Sensor with a hammer or any other tool during the installation of the Sensor, or the Sensor will lose its water-resistive properties.
• Use M3 screws to mount the Sensor.
• When mounting the case, make sure that the tightening torque applied to each screw does not exceed 0.54 N·m.

Mounting Directions

Make sure that the sensing side of the Sensor is parallel with the surface of the sensing objects. Normally, do not incline the Sensor towards the sensing object. If the object you’re sensing has a glossy surface, you can tilt the sensor by 5° to 10° as shown in the illustration. Just make sure that the sensor isn’t affected by any background objects. This adjustment will help with accurate detection.

Omron E3Z-R86